![]() ![]() Press various player 2 buttons (some of the player 1 buttons are mapped to non-displayable codes such as ALT so best to use player 2). Observe the LED on the I-PAC should display a flash pattern and then light continuously. There are no Ultimarc drivers for the I-PAC.īoot PC into DOS or Windows and run a text program such as Notepad. The drivers for this device are on the Windows CD ROM. ![]() Windows will detect the device and automatically load drivers. With Windows running plug in the USB cable. Connect normal keyboard to connector marked "KBD" (optional and does not apply in USB mode, you can leave the keyboard "as-is".) Plug one end of cable into DIN connector marked "PC" and other end to motherboard keyboard or USB connector. This is to ensure the polarised plug can only be inserted the correct way round. Note that one pin of the header is missing. If you are using the LED harness, plug it onto the 10 pin header. (But check our 4-8 way switchable sticks though!) You can connect a 4 and an 8-way stick to the same inputs. For example you might want to have side flipper buttons connected to the same inputs as fire buttons as these are used in different games. You can connect more than one switch to one I-PAC input, to perform the same function. The wire we supply in our wiring kit is 16 X 0.2 mm. Any insulated stranded wire will do providing it is thick enough to be gripped by the screw connectors. Below is a diagram showing an example of 3 joystick micro-switches connected to inputs on the I-PAC board. Some micro-switches have 3 connections – only use the ones marked "NO" and "COM". "Daisy chain" the other side of all switches together and connect to either of the "GND" terminals on PCB. You do not need to install any drivers or software from the Ultimarc CD to get the board to operate.Ĭonnect one side of each switch to the screw terminals as indicated on PCB. The board automatically detects which interface it is connected to (USB or PS/2). You want to limit coin insert to a real coin slot rather than using shift button feature.You don't want people to be able to access the MAME game config menus by using shift buttons (for example game contests etc).You use an emulator or other PC application without a key re-mapper.You may want to re-program the codes if any of the following apply: For many users there is no need to do any re-assignment, just power up and play. This matches the MAME default key codes as the table above indicates. When the board is first powered on, it contains a pre-loaded code set. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |